Test Papers

Topical MCQ Worksheet #1

Topical MCQ Worksheet - Primary 6 Science - Forces - General

Report an Error with this Question

Please describe the error you have found in this question.
Close

1.
ID 614
Difficulty

The diagram below shows a rubber tyre.



Why are there deep treads on the tyre?


This is because the deep treads _____________________.

  1. increase the stopping distance of the car

  2. reduce the amount of material used

  3. enable the tyre to move smoothly

  4. increase friction

Short Answer

D.


2.
ID 383
Difficulty

Which of the statements is/are correct?


A Smaller objects are always lighter.

B Gravity affects the weight of an object.

C The effect of weight cannot be felt but can be seen.

D The weight of an object depends on its mass only.

  1. A and B only
  2. B only
  3. C and D only
  4. B, C and D only

Short Answer

B.


3.
ID 384
Difficulty

Which of the following spring balances will show the highest reading?


  1. 1
  2. 2
  3. 3
  4. 4

Short Answer

D.


4.
ID 470
Difficulty

A spring balance was used to pull a block of wood as shown in the diagrams above. In which of the diagrams was the greatest force used?

  1. A
  2. B
  3. C
  4. D

Short Answer

D.


5.
ID 474
Difficulty

Holly used a catapult to shoot some seeds against a tree. The catapult is shown below. What should she do if she wants to increase the force of her shots?


  1. She should use less effort to pull the elastic band.
  2. She should use more effort to pull the elastic band.
  3. She should extend the length of the wooden handle.
  4. She should shorten the length of the wooden handle.

Short Answer

B.


6.
ID 476
Difficulty

Marcus throws a ball upwards. It reaches a maximum height then falls to the ground.


Which of the following statements about the moving ball is true?

  1. Gravity acts on the ball throughout.
  2. When the ball reaches its maximum height, there is no force acting on it.
  3. When the ball reaches its maximum height, gravity begins to act on it.

  4. The speed of the ball is constant throughout.

Short Answer

A.


7.
ID 481
Difficulty

Which one of the following is not a force?

  1. Mass
  2. Friction
  3. Gravity
  4. Weight

Short Answer

A.


8.
ID 483
Difficulty
When a force is applied to a stationary object, several effects are possible. Which one of the following effects is not possible?
  1. The object moves.
  2. The object rotates.
  3. The object remains unmoved.
  4. The mass of the object decreases.

Short Answer

D.


9.
ID 486
Difficulty

A boy lifted a 10g mass vertically from a table by means of a spring as shown in the diagram below. Then he measured the length of the spring. Different loads were used and the corresponding lengths of the spring were measured.



The results were then plotted on a graph as shown below.


Which one of the following does the point marked X on the graph show?

  1. The length of the spring when the 10g mass was placed on the spring.
  2. The increase in the length of the spring when the 10g mass was placed on the spring.
  3. The length of the spring when the 10g mass was removed from the spring and nothing was placed on the spring.
  4. The decrease in the length of the spring when the 10g mass was removed from the spring.

Short Answer

C.


10.
ID 504
Difficulty

The diagrams show a block of wood resting on a glass surface. Two equal forces (F) act on the wood. In which diagram will the wood definitely move?

Short Answer

D.

 

Copyright © 2005, 2006, 2007, 2008. Old School. Best viewed in 1024 x 768 with Firefox 1.0 or IE 6.

Would you like to sponsor Old School? Contact Us!